Recent Posts

Pages: [1] 2 3 ... 10
1
Crosman air pistol - General discussion / Re: Vigilante Mods
« Last post by Multigunner on October 22, 2017, 05:19:03 AM »
Beeman Coated Wadcutters work best in all my .177 revolvers (two 357, three 38T, one Umarex Colt)  and rifles.
2
Crosman air pistol - General discussion / Re: Vigilante Mods
« Last post by George Schmermund on October 21, 2017, 11:28:16 PM »
After spending some time with the previously described pellet head diameter setup it became obvious that most of the RWS pellets that were measured were not really round. That fact can have some interesting effects on POA vs POI.

To test some of these effects I've been using a bore sighter which in itself has introduced unexpected results. Well, unexpected to me.
3
There are only 2 guys who make those, Michael Chavka and BlueFork



http://www.hpasports.com/pages/product-catalog/Blue_Fork_Designs_Products?previous_url_id=0
Did HPA close the doors? They don't seem to have anything in stock except a few screw sets.
4
Crosman air pistol - General discussion / Re: size
« Last post by rangerfredbob on October 18, 2017, 06:23:45 AM »
I've always had good results using a T05 Torx bit on the breech screw without doing the flat head screw thing... I have this thing against slotted screws, they are a last resort...
5
Crosman air pistol - General discussion / Re: size
« Last post by k.boots on October 17, 2017, 09:04:23 PM »
thanks , for your quick response  I will get a couple o the slot head screw regards "ken
6
Crosman air pistol - General discussion / Re: Ordered a Trail NP Mark II Pistol
« Last post by Brutuz on October 17, 2017, 05:40:04 PM »
Great pistol but I prefer a 1911 anytime, a 1911 feels like an extention of your hand
7
Crosman air pistol - General discussion / Re: size
« Last post by Multigunner on October 17, 2017, 05:28:41 PM »
The tiny hex head of the breech/receiver mounting screw is not found in most of the cheaper hex wrench sets. Be sure to look for it before you buy.

Also I found that the small ball head hex wrench doesn't work well at all, the head of the breech screw is too shallow, I had to grind the ball tip off before it would grip well enough to turn the screw.

If you plan to do much work on these order a slot head breech screw.
8
Crosman air pistol - General discussion / Re: size
« Last post by CraigH on October 17, 2017, 01:19:50 PM »
The machine screws on 13XX and 22XX family air pistols are SAE threads.
9
Crosman air pistol - General discussion / size
« Last post by k.boots on October 17, 2017, 01:05:37 PM »
hi , going to buy a set of hex keys am I right that the crosman will be metric ???
10
Crosman air pistol - General discussion / Re: Ordered a Trail NP Mark II Pistol
« Last post by jmarchitect on October 16, 2017, 07:34:29 PM »
Sometimes the internet is there to test our patience Brutuz. I hope the Samurai fills the gap and look forward to reading all about it when it arrives.
Pages: [1] 2 3 ... 10