I put this in my 2240 and I really like it. One thing I notice is that when I pull the trigger into the first stage and then decide to not shoot it doesn't go back. Is this normal?
No - not normal. ( Would that be N³ ? ) :D
First - Is the hammer waist filled, or hammer replaced?
Second - Too fine an adjustment of either of the two stages?
Lastly - Something dragging on the trigger itself, e.g., shimming the side play?
I'm thinking it's too fine of an adjustment on the trigger I will look into it later today. I had the same issue when I put a marauder trigger group in my 2260 and I seem to remember that yeah it took some adjustment of the trigger. I will let you know what happens, thanks Craig!
I loosened the screws on the side plate and that did it! Should I take the side plate off and put in some little washers somewhere?
Not having it in hand, I would see if a VERY thin washer on the offending screw corrects the problem.
I have had this problem also...
Taking a piece of glass...
using 400 ish wet/dry sand paper ... with oil ...
in a circular motion sand sides of sear, trigger
not to forget to break the corners....
Don't over tighten side plate ....
( once I had to shim side plate )
I had some real small brass washers but they were a little big on the od dimension. A took a dremel tool and and made the od smaller, put a dab of crazy glue on them and put them in place. Perfect, problem solved thanks to your input!
:-*