Author Topic: p1701 trigger group  (Read 659 times)

0 Members and 1 Guest are viewing this topic.

Offline Jimbo

  • Crosmaniac
  • *****
  • Posts: 444
p1701 trigger group
« on: December 07, 2020, 04:06:26 PM »
I put this in my 2240 and I really like it. One thing I notice is that when I pull the trigger into the first stage and then decide to not shoot it doesn't go back. Is this normal?

Offline CraigH

  • Crosmaniac
  • *****
  • Posts: 1625
Re: p1701 trigger group
« Reply #1 on: December 07, 2020, 04:26:48 PM »
No - not normal.    ( Would that be N³ ? )    :D

First - Is the hammer waist filled, or hammer replaced?

Second - Too fine an adjustment of either of the two stages?

Lastly - Something dragging on the trigger itself, e.g., shimming the side play?
Craig
Lone Tree, Colorado

With freedom comes a terrible responsibility

Offline Jimbo

  • Crosmaniac
  • *****
  • Posts: 444
Re: p1701 trigger group
« Reply #2 on: December 07, 2020, 04:34:29 PM »
I'm thinking it's too fine of an adjustment on the trigger I will look into it later today. I had the same issue when I put a marauder trigger group in my 2260 and I seem to remember that yeah it took some adjustment of the trigger. I will let you know what happens, thanks Craig!

Offline Jimbo

  • Crosmaniac
  • *****
  • Posts: 444
Re: p1701 trigger group
« Reply #3 on: December 07, 2020, 07:44:45 PM »
I loosened the screws on the side plate and that did it! Should I take the side plate off and put in some little washers somewhere?

Offline CraigH

  • Crosmaniac
  • *****
  • Posts: 1625
Re: p1701 trigger group
« Reply #4 on: December 07, 2020, 08:09:02 PM »
Not having it in hand, I would see if a VERY thin washer on the offending screw corrects the problem.
Craig
Lone Tree, Colorado

With freedom comes a terrible responsibility

Offline KevinP

  • Crosmaniac
  • *****
  • Posts: 6651
  • Reality is a prison
Re: p1701 trigger group
« Reply #5 on: December 07, 2020, 10:55:00 PM »
I have had this problem also...

Taking a piece of glass...

using 400 ish wet/dry sand paper ... with oil ...

in a circular motion sand sides of sear, trigger

not to forget to break the corners....

Don't over tighten side plate ....

( once I had to shim side plate  )
Kevin
Albany, New York

Offline Jimbo

  • Crosmaniac
  • *****
  • Posts: 444
Re: p1701 trigger group
« Reply #6 on: December 08, 2020, 12:08:35 AM »
I had some real small brass washers but they were a little big on the od dimension. A took a dremel tool and and made the od smaller, put a dab of crazy glue on them and put them in place. Perfect, problem solved thanks to your input!

Offline CraigH

  • Crosmaniac
  • *****
  • Posts: 1625
Re: p1701 trigger group
« Reply #7 on: December 08, 2020, 01:57:25 AM »
 :-*
Craig
Lone Tree, Colorado

With freedom comes a terrible responsibility